CTHINGS.CO Edge IoT Gateway XS 2032

9.4.0 - 2026-06-18

Skyresponse support (BETA)
Wait for NTP sync at startup before starting BLE GW. Wait up to 120 seconds.
Check NTP sync status on time sync
Added time jump monitoring. Generate warning if detected. Trigger time sync if time jump is detected.
On time sync, print time drift (ms and ppm) for previous period (24h) to log
Added properties:
- 0x8012 - Device Management Enabled
- 0x9817 - Skyresponse Config (BETA)
- 0x8106 - CPU Temperature

Added backfill support
Updated MT2 to version 2.4.0
- New reporting topics: timestamped, timestamped-decoded
- New request topics: ack, ack-decoded
Support for optional secureFlags and networkId in storage-mode-event

Fixed issue where MBE backend API failed to load. This bug was present in versions 9.0.0 to 9.2.1.

This release should not be used, due to an incompatibility issue with older extender versions in secure mode.

Allow firmware download of block sizes up to 160 byte (typically 128 or 160)
Added 128-byte block broadcast support
- New optional FLAGS.B128 bit in 0x8124 - Start Firmware Broadcast (explicit override)
- New optional b128 JSON property added to start-firmware-broadcast (v13)
New property:
- 0x8011 - Device Management Connected

Do not abort firmware update (download) unless firmware is confirmed not found
Made 0x8860 - Salto Config (salto-config) readable (apiKey redacted)
Increased SHIP (Salto Space) HTTP request timeout from 15s to 30s
Changed green LED indication
- LED OFF: BLE GW init not complete
- LED ON: BLE GW init complete, management connected
- LED BLINK: GLE GW init complete, management disconnected
Increase default firmware broadcast interval to 2000 ms in secure mode (still 500 ms in legacy mode)

Reduce chance of firmware updates failing with error 250
Throttling firmware block traffic correctly for all blocks sizes during firmware update (download)
Set scan-mode when extender connects to the same route (typically after a reset)

Initial release.