Minew B10 V2 0065
Description
3rd party hardware from Minew. It has builtin rechargeable battery (90mAh) that is charged from a USB-A socket via the included cable. USB charger is not included. Will last up to 1 month between charge with default settings in unconnected mode. When ordered with Meshtech firmware, device is programmed from factory to work seamlessly and integrate fully in a Meshtech system. It has a push button for input and vibrate/LED indication to provide feedback.
The Bluetooth chipset is nRF52832 from Nordic Semiconductor.
- Firmware Model Number: 0x0065 (101)
- DFU Type: BLE SMP
Note
Before first use it is recommended to charge the device. Green LED will light while device is charging. Full charge from fully discharged will take 1.6hours with 1A 5V USB charger.
Normal operation procedure
Similar to all Meshtech trackers the Minew B10 V2 0065 is delivered in storage mode. This is to conserve power and avoid BLE advertising during transport. Normal operation device-mode for this device is unconnected. Pressing button for 1s will make device discoverable by advertising BLE storage mode advertisements, and device can be provisioned via system/gateway. If no command to provision is received while being in this state, device will go back to sleep and stop advertisements. To simplify provisioning to legacy unconnected mode, pressing button an additional time for more than 5 seconds while in storage mode will automatically switch it to legacy unconnected mode. When activating by long press, device will indicate that long press (5s+) has been received by lighting blue LED.
In unconnected mode device will advertise tracking and status updates. Alarm is activated by pressing button until device vibrate and blink blue LED 3 times. Blue LED will continue to blink periodically as long as alarm is active. Alarm state can be confirmed/cleared from system, and device will indicate with red LED and vibrate to show that alarm has been cleared.
Alarm can be manually deactivated by "OSO" button sequence when operating in alarm-mode 1 (default).
Supported Device Modes
- Storage
- Unconnected
Properties
Note
Secure Mode
0x8810 - Motion and 0x9821 - Unread Text Message are not reported in secure mode. 0x9810 - Whitelist Key is not applicable in secure mode.
Events
| Event | Version |
|---|---|
| 0x8113 - Watchdog Reset Event |
RFID
Each device also has a 13.56Mhz NFC NTAG213 sticker inside.